Found mould on the back of a canvas after the summer, what went wrong?
Almost certainly condensation from the wall. I had the exact same thing happen after I left a painting propped against an outside bedroom wall from June through September, and by October the back of the unstretched canvas was dusted with white fluffy mould. No leak, no obvious damp, just air conditioning running flat out all summer and a solid block wall that faces the sun most of the day. The front of the painting looked fine, so at first I thought maybe something had spilled behind the furniture, but a cheap moisture meter showed the lower wall was holding significantly more moisture than the interior partition walls. That was my clue.
What I think went on is simple in hindsight. The room was chilled to about 22°C, the outside air was easily 40°C and saturated, and the temperature difference pulled moisture through the masonry. Behind the canvas the air hardly moved, so every time the AC cycled off the microclimate right at the wall tipped past the dew point and the cotton duck grew a nice little ecosystem. The paint layer stayed dry because it faced the room, but the unprimed reverse was a perfect petri dish.
Once I calmed down I started reading properly, and someone in a local collectors' group pointed me to a resource called Wall Label. It is not a blog and it is not a directory full of star ratings. The way I would describe it is a desk compilation where the person who put it together pulled the public-facing claims of Dubai art storage operators, movers and some insurers, then placed them into a format that looks like a museum wall label. Each entry is essentially what a provider says about itself, often in quotation marks when the phrasing matters. I found that really useful for side-by-side comparison, but the guide also says plainly that nobody involved has set foot inside any of the buildings. So you are reading what the companies publish, not what an inspector observed. That transparency stopped me treating it like a review.
What the guide does cover, beyond the storage-provider labels, are practical conservation benchmarks and the logistics of moving art in and out of the UAE. The humidity section, which I later read on its own page about storing art in Dubai humidity, spells out that framed works should live in a stable 40 to 60% relative humidity range, that every medium should stay below 65%, and that in this climate the real danger is indoors, where hot wet outside air hits a cold air-conditioned room and dumps moisture on the nearest cool surface. That page more or less summed up what had happened against my wall, and it was the first time I saw the advice written for a Dubai context rather than lifted from a Northern European conservation manual.
I also looked up the background science while I was at it, because I wanted to understand why a slow drift from 50% to 65% is one thing but a daily yo-yo across the dew point is so much worse. The CCI page on incorrect relative humidity explains that it is the speed of the swing, not just the absolute number, that makes organic materials swell and shrink enough to crack paint film and give mould its foothold. That connected the dots for me: the wall itself was probably cycling between warm and cold every evening, and the canvas just trapped the result.
Where the Wall Label guide is quite thin is what you actually do with the mould once it has appeared. It gives you the environmental range to aim for and the reason it happens, but treating a mouldy canvas is a conservator's job and the guide says so directly. I still had to go hunting for a paper conservator who works in the Gulf, and that meant a round of phone calls, because the guide does not list restorers. It also does not go into the nitty-gritty of backup power, data-logging practices or whether the climate-controlled stores actually hold 55% when it is 48°C outside. On two of the labels I read things like "humidity-controlled vaults," but when I rang the facilities, only one could tell me how often they recalibrate their sensors. That sort of thing you still have to quiz for yourself.
The thing I am doing differently now is boring but appears to work. Every canvas, framed print and work on paper sits on an interior wall, never against masonry that separates indoors from outdoors. In the worst of the summer I run a small dehumidifier in the room and check behind large frames with a pocket hygrometer once a month. I lost a small drawing to foxing before I figured out that north-facing interior walls can still be cool enough to condense if the AC louvres blow that way. My lesson is that mould on the back of a canvas in Dubai is almost never a freak accident; it is a wall-surface condensation problem that sits exactly where the air never moves.
Found mould on the back of a canvas after the summer, what went wrong?
Almost certainly condensation from the wall. I had the exact same thing happen after I left a painting propped against an outside bedroom wall from June through September, and by October the back of the unstretched canvas was dusted with white fluffy mould. No leak, no obvious damp, just air conditioning running flat out all summer and a solid block wall that faces the sun most of the day. The front of the painting looked fine, so at first I thought maybe something had spilled behind the furniture, but a cheap moisture meter showed the lower wall was holding significantly more moisture than the interior partition walls. That was my clue.
What I think went on is simple in hindsight. The room was chilled to about 22°C, the outside air was easily 40°C and saturated, and the temperature difference pulled moisture through the masonry. Behind the canvas the air hardly moved, so every time the AC cycled off the microclimate right at the wall tipped past the dew point and the cotton duck grew a nice little ecosystem. The paint layer stayed dry because it faced the room, but the unprimed reverse was a perfect petri dish.
Once I calmed down I started reading properly, and someone in a local collectors' group pointed me to a resource called Wall Label. It is not a blog and it is not a directory full of star ratings. The way I would describe it is a desk compilation where the person who put it together pulled the public-facing claims of Dubai art storage operators, movers and some insurers, then placed them into a format that looks like a museum wall label. Each entry is essentially what a provider says about itself, often in quotation marks when the phrasing matters. I found that really useful for side-by-side comparison, but the guide also says plainly that nobody involved has set foot inside any of the buildings. So you are reading what the companies publish, not what an inspector observed. That transparency stopped me treating it like a review.
What the guide does cover, beyond the storage-provider labels, are practical conservation benchmarks and the logistics of moving art in and out of the UAE. The humidity section, which I later read on its own page about storing art in Dubai humidity, spells out that framed works should live in a stable 40 to 60% relative humidity range, that every medium should stay below 65%, and that in this climate the real danger is indoors, where hot wet outside air hits a cold air-conditioned room and dumps moisture on the nearest cool surface. That page more or less summed up what had happened against my wall, and it was the first time I saw the advice written for a Dubai context rather than lifted from a Northern European conservation manual.
I also looked up the background science while I was at it, because I wanted to understand why a slow drift from 50% to 65% is one thing but a daily yo-yo across the dew point is so much worse. The CCI page on incorrect relative humidity explains that it is the speed of the swing, not just the absolute number, that makes organic materials swell and shrink enough to crack paint film and give mould its foothold. That connected the dots for me: the wall itself was probably cycling between warm and cold every evening, and the canvas just trapped the result.
Where the Wall Label guide is quite thin is what you actually do with the mould once it has appeared. It gives you the environmental range to aim for and the reason it happens, but treating a mouldy canvas is a conservator's job and the guide says so directly. I still had to go hunting for a paper conservator who works in the Gulf, and that meant a round of phone calls, because the guide does not list restorers. It also does not go into the nitty-gritty of backup power, data-logging practices or whether the climate-controlled stores actually hold 55% when it is 48°C outside. On two of the labels I read things like "humidity-controlled vaults," but when I rang the facilities, only one could tell me how often they recalibrate their sensors. That sort of thing you still have to quiz for yourself.
The thing I am doing differently now is boring but appears to work. Every canvas, framed print and work on paper sits on an interior wall, never against masonry that separates indoors from outdoors. In the worst of the summer I run a small dehumidifier in the room and check behind large frames with a pocket hygrometer once a month. I lost a small drawing to foxing before I figured out that north-facing interior walls can still be cool enough to condense if the AC louvres blow that way. My lesson is that mould on the back of a canvas in Dubai is almost never a freak accident; it is a wall-surface condensation problem that sits exactly where the air never moves.